2023-01-11 19:42:06 +00:00
# X10 Decoder
## Introduction
This is a protocol decoder for the Flipper Zero to decode the X10 series of devices when doing a read from the Sub-GHz menu.
2023-01-11 22:08:22 +00:00
2023-01-11 19:42:06 +00:00
## Validation
2023-09-08 15:02:33 +00:00
NOTE: As an Amazon affiliate I (CodeAllNight) earn from qualifying purchases from the amzn.to links below.
2023-01-11 19:42:06 +00:00
The code was tested with the "X10 Camera Control System Remote Control Model CR12A" which you can purchase from
https://amzn.to/3issZPs and should also be compatible with signals from https://amzn.to/3QEF7cM
The receiver I used is no longer for sale, but a similar module can be purchased from https://amzn.to/3CFWy6M
The House (Channel) is A-P setting.
The Unit (Button) is 1-16 setting (slider switches between 1-8 and 9-16).
The signal is "On" or "Off". For each channel there is also a "Dim" or "Bright".
The signal is broadcast at 310MHz with a modulation of AM650.
## Installation Directions
This project is intended to be overlayed on top of an existing firmware repo.
2023-01-11 22:01:12 +00:00
- Clone, Build & Deploy an existing flipper zero firmware repo. See this [tutorial ](/firmware/updating/README.md ) for updating firmware.
2023-01-11 19:45:03 +00:00
- Add the [x10.c ](./x10.c ) file to the \lib\subghz\protocols folder
- Add the [x10.h ](./x10.h ) file to the \lib\subghz\protocols folder
2023-01-11 19:42:06 +00:00
- Update the \lib\subghz\protocols\protocol_items.h file
- After all of the other #include statements add the following line:
```
#include "x10.h"
```
- Update the \lib\subghz\protocols\protocol_items.c file
- After all of the other & subghz_protocol_{name}, entries add the following:
```
& subghz_protocol_x10,
```
2023-01-11 19:45:03 +00:00
- NOTE: Your updated files should look similar to the [protocol_items.c ](./protocol_items.c ) and [protocol_items.h ](./protocol_items.h ) in this project.
2023-01-11 22:02:31 +00:00
- Build & deploy the firmware. See this [tutorial ](/firmware/updating/README.md ) for updating firmware.
2023-01-11 19:42:06 +00:00
## Running the updated firmware
These directions assume you are starting at the flipper desktop. If not, please press the back button until you are at the desktop.
- Press the OK button on the flipper to pull up the main menu.
- Choose "Sub-GHz" from the menu.
- Choose "Read" from the sub-menu.
- Choose the "Config" option (Click the left arrow)
- Change the frequency to 310.00 (Click the left arrow multiple times)
- Confirm that Hopping is OFF.
- Confirm the Modulation is AM650.
- Press the BACK button.
- The flipper should say "Scanning... and show 310.00 AM 00/50"
Click a button on your X10 remote.
The flipper should show "X10 < some code> "
- Press the OK button on the flipper
It should show the Channel, Button number and the kind of button (ON/OFF/DIM/BRIGHT).
